[Al Skierkiewicz]

OK Ladies and gentlemen,
Time to quote the rules from Section 01 Introduction...
FRAME PERIMETER – the polygon defined by the outer-most set of exterior vertices on the HOSTBOT (without the BUMPERS attached) that are within the BUMPER ZONE.

To determine the FRAME PERIMETER, wrap a piece of string around the HOSTBOT at the level of the BUMPER ZONE - the string describes this polygon.
Note: to permit a simplified definition of the FRAME PERIMETER and encourage a tight, robust connection between the BUMPERS and the FRAME PERIMETER, minor protrusions such as bolt heads, fastener ends, rivets, etc are excluded from the determination of the FRAME PERIMETER.

This kind of says it all. Language similar to this was the rule last year as well. Hold a string around the frame and that describes the FRAME PERIMETER. The FRAME PERIMETER must be protected by bumpers and this year the rule under Section 04-The Robot R07-K allows some leeway that was not present last year, i.e.some gaps and some unsupported bumpers. The "T" robot last year and "hourglass" robot shown above fall under the same rule. A string wrapped around the robot at the height of the bumper zone would bridge the opening and therefore require bumpers attached to the robot everywhere the string exists. I failed a "T" design last year for the violation. I explained the rule and assisted the team in becoming compliant. As they were under size and underweight and had time to complete the needed mods, they played. In light of other game rules, (cough herding cough) it is easy to see why the FRAME PERIMETER is so defined.