[Daniel_H]

there's 3 problems we're facing right now that might have simple solutions we can't see:

1 - I Imaged our '10 classmate, installed the 3 update packs (LV, utility and diver station) and LabVIEW is not opening.
It's curious, because the imaging tool is working normally, I just imaged our cRIO.. and the driver station is working normally as well.

2 - I installed everything in my notebook, I even got the cRIO communicating with LabVIEW, but now my computer can't see it anymore (I had it working for a few hours) no matter what I do. I checked the IPs, reimaged, checked battery, changed the cable.. (I'm using a cross cable from cRIO's port1 to my notebook's ethernet port).

3 - Not to mention the cypress board, that is perfectly recognized by the classmate's driver station, but the driver station in my notebook can't see. The sad part is that the PSoC programmer sees and writes normally in it.

Summarizing: we got our KOP only yesterday and we are facing problems in very fundamental steps. We have stuff working part on a notebook, part on the classmate, but not everything in one place, and the way things are, we can't go on, because there's no way to send code to cRIO right now

anyone had similar problems?
what should I do?