[mattiej]

Oh what our team breaks....
So I was testing our cRIO with my code, and when I first booted up the robot I noticed that there was already code on it for some reason (we had it reimaged at kickoff and I hadn't deployed any on to there, just ran from the computer). So I went to go reimage it. I followed all of the instructions, and it was going fine, until I get an error. I don't have a picture of the error at the moment, I will get it later, but it basically said that there was an error (error60 to be exact), and then it gave me a list of file. Later down in the explanation, it said the IP for this device was in use. I checked the lab, made sure all the computers were off, as well as all phones. Went to go and run the image and saw that the driver station wasn't detecting the cRIO and LavVIEW couldn't deploy to it. When pulling up the imaging software, the settings of the cRIO had been completely reset including IP. After trying to run the image again, I got the same error. I then turned the cRIO off, and rebooted in in safe mode so that the imaging would reformat my cRIO. I did that with no errors, and still ended up with the exact same error as the first time.

I'm completely stumped here. I followed all documentation and tried to look up as much info as I could on this issue, but I had no luck. Any suggestions? I plan to contact NI about it but we already have about 60-70% of the robot built (including drive) and we really need to test it to see if it works.

Thanks so much in advance if you can help!