Thread: Pulley Radius: how to factor this into calculations?
View Single Post
  #3   Spotlight this post!  
Unread 19-01-2011, 22:57
theprgramerdude theprgramerdude is offline
WPI Freshman
AKA: Alex
FRC #2503 (Warrior Robotics)
Team Role: Mentor
  
Join Date: Feb 2010
Rookie Year: 2008
Location: Brainerd, Minnesota
Posts: 347
theprgramerdude has much to be proud oftheprgramerdude has much to be proud oftheprgramerdude has much to be proud oftheprgramerdude has much to be proud oftheprgramerdude has much to be proud oftheprgramerdude has much to be proud oftheprgramerdude has much to be proud oftheprgramerdude has much to be proud oftheprgramerdude has much to be proud oftheprgramerdude has much to be proud of
Re: Pulley Radius: how to factor this into calculations?
Would having a pulley with too small a diameter really matter in FRC-application type loads? I'm thinking of a scenario in which a high load on a tightly wrapped belt could cause it to suffer extreme fatigue and snap.
__________________
Attending: MN Duluth Regional