|
Re: Unable to Assign ID to Jaguar with BD-COMM
Quote:
|
The first thing I would check is your termination resistor. Is it shorting the CAN bus together?
|
Not necessarily the problem. Since the picture makes it appear as if the Jaguar is directly connected over the serial port, the CAN bus shouldn't even be used yet (It would be purely serial communication).
If you can talk to the Jaguar try re-flashing its firmware, if not then try the BDC-Comm "Recover Jaguar" setting to see if it is stuck in a boot-loader state.
__________________
- Ian McInerney
Alumni & Mentor, Team 2022 Titan Robotics
Junior, Iowa State University majoring in Electrical Engineering
|