Thread: Motor balancing (encoders?)
View Single Post
  #7   Spotlight this post!  
Unread 30-01-2011, 17:50
davidthefat davidthefat is offline
Alumni
AKA: David Yoon
FRC #0589 (Falkons)
Team Role: Alumni
  
Join Date: Jan 2011
Rookie Year: 2010
Location: California
Posts: 792
davidthefat has much to be proud ofdavidthefat has much to be proud ofdavidthefat has much to be proud ofdavidthefat has much to be proud ofdavidthefat has much to be proud ofdavidthefat has much to be proud ofdavidthefat has much to be proud ofdavidthefat has much to be proud ofdavidthefat has much to be proud of
Re: Motor balancing (encoders?)
Quote:
Originally Posted by Alan Anderson View Post
This is not physically possible. The Brake/Coast selection is made by installing a jumper between either the first and second or the second and third pins of a three-pin header.

If you did manage to connect both the Brake and Jumper pins to the control pin at the same time, you would short out the Victor's 5 volt power.



It sounds like one Victor was set to Brake and another was set to Coast.
I guess that was it. I never actually looked at the victors; the electronics guy told me that.
__________________
Do not say what can or cannot be done, but, instead, say what must be done for the task at hand must be accomplished.
Reply With Quote