|
Re: eStop Robotics CCI board
Check to see if it installed properly.
Windows 7 may not have located the proper driver for it. - Go to Start -> Devices & printers
- See if the eStop device is listed (any warning signs?)
- Double-click on the eStop device icon to open a pop-up
- On the pop-up go to the Hardware tab
- What does it say for Device Status?
__________________
"Rationality is our distinguishing characteristic - it's what sets us apart from the beasts." - Aristotle
Last edited by Mark McLeod : 01-30-2011 at 10:45 PM.
|