Thread: Minibot Motor Fastener Size?
View Single Post
  #2   Spotlight this post!  
Unread 31-01-2011, 21:39
Bill_B Bill_B is offline
You cannot not make a difference
FRC #2170
  
Join Date: Jan 2010
Rookie Year: 2004
Location: Connecticut
Posts: 1,099
Bill_B has a reputation beyond reputeBill_B has a reputation beyond reputeBill_B has a reputation beyond reputeBill_B has a reputation beyond reputeBill_B has a reputation beyond reputeBill_B has a reputation beyond reputeBill_B has a reputation beyond reputeBill_B has a reputation beyond reputeBill_B has a reputation beyond reputeBill_B has a reputation beyond reputeBill_B has a reputation beyond repute
Re: Minibot Motor Fastener Size?
There are two threaded holes on the gearbox face. They are M3xP0.5 despite what a drawing I saw once that claimed they were M2. Not sure about the penetration allowed into the gearbox housing before interference with the gears will happen. Also not sure about the three screws holding the gearbox on. Pretty good guess is that they are metric. Might even be M3 too. Just take one out and try it in the mounting hole. LMK-OK?
__________________
Nature's Fury FLL team 830 - F L eLements
FRC team 2170 - Titanium Tomahawks