[Danny Diaz]

We are having this problem too. We successfully used the Cypress board last year, but this year we are having big problems getting the software installed "correctly" - I say this because the "CyMiniProg3Service" doesn't even appear in the Service Manager, so it looks like a software install problem. When we launch any of the PSOC utilities (programmer, creator) we get this same error. This is obviously not acceptable, because the control of our robot is very dependent upon analog input to the Cypress board.

We're actively working on this, and we have multiple approaches being worked on. We'll let you know if any of them pan out.

-Danny