Thread: can't connect jags to bdc-comm
View Single Post
  #6   Spotlight this post!  
Unread 01-02-2011, 13:40
dyanoshak dyanoshak is offline
Registered User
AKA: David Yanoshak
FRC #2158 (ausTIN CANs)
Team Role: Mentor
  
Join Date: Dec 2007
Rookie Year: 2007
Location: Austin, TX
Posts: 189
dyanoshak has a reputation beyond reputedyanoshak has a reputation beyond reputedyanoshak has a reputation beyond reputedyanoshak has a reputation beyond reputedyanoshak has a reputation beyond reputedyanoshak has a reputation beyond reputedyanoshak has a reputation beyond reputedyanoshak has a reputation beyond reputedyanoshak has a reputation beyond reputedyanoshak has a reputation beyond reputedyanoshak has a reputation beyond repute
Re: can't connect jags to bdc-comm
In addition to the previous posts, I recommend that you double check the adapter you made to make sure the RX and TX lines are connected properly. Also confirm that your 6p6c cable going from the adapter to the Black Jag is "reversed," meaning pin 1 -> pin 1, pin 2 -> pin 2, and so on. See the Getting Started Guide for a good diagram.

Next I would try to reset the Jaguar to factory defaults by powering up while holding the user button with a paperclip. You can release it as the Jaguar flashes a slow green/red.

-David
Reply With Quote