[4molo]

Bricked a gray jag during firmware upgrade. Went through the process to get it back and got my LED back. But When I connect up a black jag as bridge and the gray jag, then start up BDC Comm, it only recognizes the black jag on the CAN. I've got no board ID for the gray jag so I can reassign. I attempt to run recover device using the gray jag firmware with the black jag as bridge to the gray jag when BDC Comm only recognizes the black jag, but that ended up bricking the black jag (which I was able to recover when I took the gray off the CAN). I tried changing the board ID of the black jag to see if there was a ID conflict, but still only recognized the black jag. I'm connecting via a USB-to-Serial-to-RJ12 bridge cable and had no problems updating 2 black jags and 1 gray jag before this. So the question is how do I get a board ID back on the gray jag?