|
Re: Minibot dimensions
Guys,
The official answer is your minibot in all configurations must fit and remain inside a 12" cube.
<R97> The MINIBOT will be inspected for compliance with the dimension constraints specified in Rule <R91> by being placed within a Sizing Device that has inside surface dimensions consistent with the rule. Other than resting on the floor of the Sizing Device, no part of the MINIBOT can break the plane of the sides or top of the Sizing Device during size inspection.
At the beginning of inspection your minibot will go into the box and be weighed before proceeding with inspection.
__________________
Good Luck All. Learn something new, everyday!
Al
WB9UVJ
www.wildstang.org
________________________
Storming the Tower since 1996.
|