Thread: Can't enumerate the entire bus
View Single Post
  #1   Spotlight this post!  
Unread 02-13-2011, 03:38 PM
linuxboy linuxboy is offline
Registered User
AKA: Oliver Graff
FRC #3780
Team Role: Alumni
  
Join Date: Nov 2010
Rookie Year: 2009
Location: MI, USA
Posts: 217
linuxboy has much to be proud oflinuxboy has much to be proud oflinuxboy has much to be proud oflinuxboy has much to be proud oflinuxboy has much to be proud oflinuxboy has much to be proud oflinuxboy has much to be proud oflinuxboy has much to be proud oflinuxboy has much to be proud of
Can't enumerate the entire bus
Hi all,
Last night I finally got CAN working reliably (or so I thought). This morning I came in and decided to write code for using the Jags on the cRIO instead of just using BDC-COMM. Somewhere when testing I started to get errors about a firmware version being 0. I connected it to BDC-COMM again and found that it wasn't enumerating the second jag on the bus. I switched the order that the Jags were wired and it recognized the one that became the first Jag after the switch (the one that wasn't getting enumerated before). Then I tried using 3 Jags and was able to (unreliably) read the second but not the last jag in the chain.

Any ideas guys?

Thanks
Reply With Quote