Thread: Deploying stand-alone program on crio.
View Single Post
  #5   Spotlight this post!  
Unread 15-02-2011, 13:41
gordo161101 gordo161101 is offline
Registered User
AKA: G. Lange
FRC #2439 (BHS Robotics)
Team Role: Mentor
  
Join Date: Jan 2011
Rookie Year: 2009
Location: Hawaii
Posts: 4
gordo161101 is an unknown quantity at this point
Re: Deploying stand-alone program on crio.
Trying to get the robot application to be loaded and run when the crio is powered off and powered back on. LabView provides a procedure for doing this, referring to this as running in stand-alone mode, have not found anything similar for Java. I assume this is needed for the competition.

Initially thought that the way netbeans loads the code this was basically done but is not. Powering off the crio and back on does not run the robot application. Have to load via netbeans again.

So far none of the suggestions has helped. Thanks.
Reply With Quote