[Fletch1373]

Originally Posted by Datalore

Can the radio be connected to the 5 volt supply on the Power Distribution board?

Can the 5 volt supply on the Power Distribution board be split to power both the camera and the radio?

Is there a size limit on capacitors?

Can the Operator Console communicate (without driver input) to the robot during the autonomous period?

no, the radio can only be connected to the dedicated 12V connection through the Converter provided in the KOP(per rule R38.B)

<R38.B> The radio power feed must be connected via the 5V converter (model # TBJ12DK025Z) to the marked 12 Vdc supply terminals located at the end of the PD Board (i.e. the terminals located between the indicator LEDs, and not the main WAGO connectors along the sides of the PD Board). No other electrical load can be connected to these terminals (please see the 2011 Robot Power Distribution Diagram posted online at www.usfirst.org/frc/kitofparts for wiring information).

I don't know about the capacitors, I haven't seen a rule limiting their use.

If I remember correctly, the DS is always communicating with the robot(even during autonomous), however, rules disallow driver input during this time period, such as touching joysticks