Thread: Viair 90 series compressor
View Single Post
  #3   Spotlight this post!  
Unread 17-02-2011, 08:15
Juggernaut's Avatar
Juggernaut Juggernaut is offline
Registered User
AKA: Jeff
FRC #5404 (Gearaffes)
Team Role: Mentor
  
Join Date: Jun 2006
Rookie Year: 2001
Location: Lansdale, PA
Posts: 15
Juggernaut is an unknown quantity at this point
Re: Viair 90 series compressor
I just found a conflict in the rules. R66 says a working pressure of 125 while R69 says a working pressure of 120psi. I will have to post in the Q & A about this.

Quote:
<R69> Compressed air for the pneumatic system on the ROBOT must be provided by one and only one compressor. This compressor may be either the compressor from the KOP, or an equivalent compressor that does not exceed any of the KOP compressor performance specifications (specifically: nominal 12v, 1.03 cfm flow rate, 120psi maximum working pressure). Compressed air shall not come from any other source. Off-board compressors must be controlled and powered by the ROBOT.