|
Re: Removing Modules from cRIO
The analog breakout jumpered on the two leftmost pins (towards the end of the board and the center pin) is required for battery voltage to be transmitted to the driver's station AND FMS. The breakout must be installed on a NI 9201 module in slot 1.
__________________
2011 NJ Regional #1 seed, winner
2011 Virginia Regional winner
2010 New Jersey Regional Winner
2010 Virginia Regional Winner (15-0  )
2010 Curie Finalists
Editor - alltechdaily.com
Last edited by bensherman : 18-02-2011 at 12:53.
|