Quote:
Originally Posted by MarcD79
As the rules state, the tube is measured at the smallest section & can be between 7-8 inches. We had the official "C" shaped template that slid over the tube as you inflate them. When the tube was inflated to make contact with the template, the inflation was completed. If the corners (triangle tube) appeared to be larger than the sides, that was considered acceptable.
|
That makes things even more interesting. Perhaps it is the FIRST spec that needs to change then.
I have no problem with the size of the tubes being different than what teams have been working with, the specs have been there the whole time. I do have a problem with tubes not fitting through the slots, that just doesn't make any sense.