|
Re: Robot Code not taken
The proper steps for code deployment are:
1. In the Project Explorer click the '+' next to "Build Specifications" under the "RT Compact RIO" menu.
2. Right click on "FRC Robot Boot-Up Deployment" and click "Build"
3. After the code finishes building right click on the same place again and click "Run as startup"
4. After the code is loaded Labview will pop up a dialog asking to reboot the cRIO. Allow it to reboot.
Is that the process you were following?
__________________
2007 Wisconsin Regional Highest Rookie Seed & Regional Finalists (Thanks 930 & 2039)
2008 MN Regional Semifinalists (Thanks 2472 & 1756)
2009 Northstar Regional Semifinalists (Thanks 171 & 525)
|