|
Re: LogoMotion Learnings from Scrimmages
Quote:
Originally Posted by MarcD79
As the rules state, the tube is measured at the smallest section & can be between 7-8 inches. We had the official "C" shaped template that slid over the tube as you inflate them. When the tube was inflated to make contact with the template, the inflation was completed. If the corners (triangle tube) appeared to be larger than the sides, that was considered acceptable.
|
If I remember correctly, 2007 had a similar object, but it was pressure that was required so we barely used it.
I figure field reset will be told to inflate the tubes somewhere between the 7-8 inch thickness, or until the tubes are inflated to their shape and firm to the touch.
__________________
"For every great theory about design, there is a better and contradictory theory about design. And don't let the irony of that escape you."
|