While we were testing our robot we noticed that our solenoids and other outputs would seem to completely loose power for about a half a second every 63 seconds.
We searched on Chief Delphi and found this thread from 2010 about a similar problem. However, the problem was never resolved.
http://www.chiefdelphi.com/forums/sh...d.php?p=947244
We have tried running blank code, only enabling the solenoids, and we still had the problem. We ran the program with watchdog enabled and disabled and had the problem, and had the problem with watchdog completely taken out of the program. The whole robot looses power and the lights on our line sensors flash, and the motors seem to stutter.
Has anyone else had this problem? If so, did you find a solution?