Thread: Minibot Motor Press Fit
View Single Post
  #14   Spotlight this post!  
Unread 03-03-2011, 17:35
Trent B Trent B is offline
College Mentor
AKA: Trent Borman
no team (Surviving Grad School)
Team Role: Alumni
  
Join Date: Dec 2008
Rookie Year: 2008
Location: Ames, IA
Posts: 479
Trent B is a splendid one to beholdTrent B is a splendid one to beholdTrent B is a splendid one to beholdTrent B is a splendid one to beholdTrent B is a splendid one to beholdTrent B is a splendid one to beholdTrent B is a splendid one to beholdTrent B is a splendid one to behold
Send a message via AIM to Trent B Send a message via Yahoo to Trent B
Re: Minibot Motor Press Fit
I was going to mention that, it is actually made for press fitting two smooth objects together, oddly the local autoparts stores here didn't sell it even though it is often used for bearings in cars. So we settled for red loctite which works in low torque situations (like our lifter)

But similarly, I am not sure 638 is technically allowed on the minibot where-as Loctite designed for thread-locking is.
__________________
Former 2502 (Talon) Captain and 3928 (Neutrino) Mentor, currently teamless and attending Penn State for graduate school.
Have questions about Iowa State University or Penn State University? Feel free to email or PM me
Reply With Quote