Thread: cRIO says: FRC_UserProgram failed to load.
View Single Post
  #14   Spotlight this post!  
Unread 03-03-2011, 11:29 PM
taichichuan's Avatar
taichichuan taichichuan is offline
Software Mentor
AKA: Mike Anderson
FRC #0116 (Epsilon Delta)
Team Role: Mentor
  
Join Date: Feb 2010
Rookie Year: 2010
Location: Herndon, VA
Posts: 328
taichichuan has much to be proud oftaichichuan has much to be proud oftaichichuan has much to be proud oftaichichuan has much to be proud oftaichichuan has much to be proud oftaichichuan has much to be proud oftaichichuan has much to be proud oftaichichuan has much to be proud oftaichichuan has much to be proud oftaichichuan has much to be proud of
Send a message via AIM to taichichuan
Re: cRIO says: FRC_UserProgram failed to load.
Quote:
Originally Posted by Larry R View Post
Yes, we are using a camera but we haven't added the code for that. Our original code ran the robot very well as a kernel task.

We tried to compile and deploy SimpleTemplate, made sure -mlongcall was there but had a new error message: I/O Error popup even though in the left pane of Windriver says we can make a successful connection to the cRIO.

At first, I was connected via the router and got the error. Next, I used a crossover cable from the Windriver laptop directly to Port 1 on the cRIO and got the same I/O popup error when deploying.

I've never seen so many problems trying to deploy code on a robot!

I set up the cRIO, a PD, Digital Sidecar, D-Link and a couple spikes on a sheet of polycarb to make a sort of dev platform. This weekend we will try all this with a different laptop.

I have an additional question: If I want to use FTP instead of deploy what is the path of the compiled .out file and is it called simply .out? I'm asking this because I can FTP to and from the cRIO with no problem....thanks to Mike's suggestions.
The path is /ni-rt/system/FRC_UserProgram.out.

HTH,

Mike
Reply With Quote