View Single Post
  #21   Spotlight this post!  
Unread 04-03-2011, 06:42
boomergeek's Avatar
boomergeek boomergeek is offline
Registered User
AKA: Mr. D (Dick DiPasquale)
FRC #0241 (Pinkerton Robotics)
Team Role: Mentor
 
Join Date: Feb 2009
Rookie Year: 2009
Location: Derry, NH
Posts: 191
boomergeek has a brilliant futureboomergeek has a brilliant futureboomergeek has a brilliant futureboomergeek has a brilliant futureboomergeek has a brilliant futureboomergeek has a brilliant futureboomergeek has a brilliant futureboomergeek has a brilliant futureboomergeek has a brilliant futureboomergeek has a brilliant futureboomergeek has a brilliant future
Re: Minibot Motor Press Fit

Quote:
Originally Posted by Mr V View Post
We found that in aluminum a sharp 3/32" bit at the right feed rate produces a hole that is a nice press fit on the tetrix motor.
We found the same thing. It actually help if your lathe drill chuck is .002" off center.

Since the shafts are long, we used the drill press as the press fit device (moving the bed into the chuck).
Reply With Quote