Quote:
Originally Posted by Camren
|
Looks like your copy of Labview has not been updated. On your programming computer you need to get the Labview Update and Utilities Update from
this page
On your Classmate or other Driver Station computer you need to get the Driver Station Update from the same page.
After updating Labview your Open 2 Motor VI will become a polymorphic VI. This means it will have a box under it like your solenoid VIs do to select the type of motor controller (Jaguar, Victor, CAN Jaguar). Change the box to Victor and you should be good to go with the Drive motors.
Does that solenoid code work properly? If you want to set a single solenoid using one of two buttons you should use a single Solenoid Set VI and an AND to combine the button signals. If they are double solenoids which is what your comments seem to suggest then you may be able to use the code in a similar way to how it is currently written but you will have to pass a device reference for a single solenoid on the appropriate channel to each solenoid set VI, not the same device reference to both.