|
Re: Stupid servo
"Have you installed a jumper on the pins next to the PWM's so that the servo gets 5 volt power?"
Yep
"Stupid question: did you enable the robot from the Driver Station?"
Yep n_n b
If you can move it by hand (and it doesn't try to resist) when the robot is on but there's no programming, it is not wired correctly* Try a different servo.
No resistance at all so I'll try a different one tomorrow but I remember trying it on a vex robot and it worked fine. I don't know how the wiring could be wrong it's on the dsc with a jumper right next to it. I put the yellow to sig and red and black to positive and negative.
|