[Ken Streeter]

Originally Posted by Straberrie

Last time we tested out robot before ship date, the voltage was not outputting on the classmate screen.

The voltage on classmate displayed "0.00" the entire time.

The most common cause of this problem is a lack of power to the analog breakout card. Check to confirm that the LED on the analog breakout is lit. If the LED is not lit, check the power wire to the PDB and the circuit breaker in the PDB.

The second most common cause (as mentioned by byteit101) is to ensure that the jumper on the analog breakout card is correctly positioned.

I would note that having voltage correctly displayed on the classmate is a requirement to participate in practice matches at regional events, so you'll want to fix this ASAP when you get to your first event.

Are you using any analog inputs on the analog breakout?