Thread: Take the "Bane" out of your Banebot P60s - Solution to Banebot P60 Weaknesses
View Single Post
  #34   Spotlight this post!  
Unread 11-03-2011, 08:09
Teched3 Teched3 is offline
Hodge1
FRC #0175 (BuzzRobotics)
Team Role: Mentor
  
Join Date: Apr 2006
Rookie Year: 1996
Location: Connecticut
Posts: 319
Teched3 has much to be proud ofTeched3 has much to be proud ofTeched3 has much to be proud ofTeched3 has much to be proud ofTeched3 has much to be proud ofTeched3 has much to be proud ofTeched3 has much to be proud ofTeched3 has much to be proud ofTeched3 has much to be proud of
Smile Re: Take the "Bane" out of your Banebot P60s - Solution to Banebot P60 Weaknesses
Quote:
Originally Posted by fox46 View Post
Ether, here are the hand drawings that the guys have been working from. Not all the dimensions are on them but anything that is missing is pretty easy to figure out. Hope this helps.
All excellent feedback regarding the banebot mods. That is what this "project" is all about. Some of us want a Corrvette for the price of a Fiat. Some things I noticed for those of you planning on modifying the banebots:

The drawing is missing the rear guide pin on the output shaft that centers in the 3rd stage carrier plate. Is it machined integral with the output shaft, or a pin pressed into the shaft.

Are you using extended inner race bearings where the spacer is located?

Is there any problem with the spacer moving off center when you grease and reassemble?

Banebots has been very responsive to suggestions for improvement. You should talk to them. Thank you for doing this.
__________________
Sweat the details
Why is there never enough time to do it right, but always enough time to do it again!
Even if you're on the right track, if you sit still, you'll get run over!!!
Reply With Quote