Thread: Minibot motors
View Single Post
  #38   Spotlight this post!  
Unread 16-03-2011, 11:43
DonRotolo's Avatar
DonRotolo DonRotolo is offline
Back to humble
FRC #0832
Team Role: Mentor
 
Join Date: Jan 2005
Rookie Year: 2005
Location: Atlanta GA
Posts: 7,017
DonRotolo has a reputation beyond reputeDonRotolo has a reputation beyond reputeDonRotolo has a reputation beyond reputeDonRotolo has a reputation beyond reputeDonRotolo has a reputation beyond reputeDonRotolo has a reputation beyond reputeDonRotolo has a reputation beyond reputeDonRotolo has a reputation beyond reputeDonRotolo has a reputation beyond reputeDonRotolo has a reputation beyond reputeDonRotolo has a reputation beyond repute
Re: Minibot motors

Quote:
Originally Posted by joeweber View Post
I place rubber electrical tap over this shaft which is legal but there is nothing else small enough that is legal.
*cough* latex tubing *cough*
Quote:
Originally Posted by Captaindan View Post
but a 3sec robot is possible with proper engineering it is totally up to the builder/team
THREE seconds? Goodness, we're down to one point three seconds now.
Quote:
Originally Posted by JOClarke View Post
Does anybody know what size the screws that connect the tetrix motor to the transmission plate are?
I agree with above, I get 2.5 mm x 0.45 pitch (which is standard). McMaster has them for about $4 a box of 100, depending on length.
__________________

I am N2IRZ - What's your callsign?
Reply With Quote