Quote:
Originally Posted by pfreivald
We're still trying to figure out why we're getting COM drops.
Our wiring is sound (and connections both strain gauged and either hot glued or taped).
Our power appears to be constant...
...and yet, a few times at FLR, and a few times during practice, our bridge likes to reboot, killing our robot for about a minute.
Suggestions, anyone?
|
What power connector are you using? There seems to be a hint that the DAP's power pin might be a tad smaller than an apparently correct connector is designed for. If you aren't using the connector that came with the DAP, it might be losing contact due to vibration of the board inside the case.