Thread: Direct drive minibot - output diameter?
View Single Post
  #3   Spotlight this post!  
Unread 16-03-2011, 19:12
NOV8R's Avatar
NOV8R NOV8R is offline
Registered User
AKA: Chuck Brant
FRC #1583
Team Role: Mentor
  
Join Date: Jan 2007
Rookie Year: 2006
Location: Centennial, Colorado
Posts: 209
NOV8R has much to be proud ofNOV8R has much to be proud ofNOV8R has much to be proud ofNOV8R has much to be proud ofNOV8R has much to be proud ofNOV8R has much to be proud ofNOV8R has much to be proud ofNOV8R has much to be proud of
Re: Direct drive minibot - output diameter?
3/8 inch is good. Remove the spur gear . The motor shaft is 2.5 mm. A two inch long piece of 6061 drilled with a 3/32 bit can then be carefully pressed on with thread locker.