|
Re: Our Crio Won't Run deployed Code and there are no Error messages
I've got another direction to look, as well.
Test your driver controls.
Go to the Driver Station Setup tab and check to see that your USB devices are all listed on the right.
Push a button on each of your joysticks one-at-a-time and the corresponding USB input should light up blue.
If you're using the Cypress, that entry may already be blue if one of your switches is normally closed.
We see a lot of this type of behavior (lack of controls) when a bunch of stuff is plugged into a single USB hub and it isn't getting the power it needs to run everything.
__________________
"Rationality is our distinguishing characteristic - it's what sets us apart from the beasts." - Aristotle
Last edited by Mark McLeod : 22-03-2011 at 07:35.
|