Thread: Solution: Variable position of cylinder in compliance with <R74>
View Single Post
  #6   Spotlight this post!  
Unread 29-03-2011, 16:58
cjwmam cjwmam is offline
Registered User
AKA: Jim Hackbarth
FRC #2194 (Fondy Fire)
Team Role: Mentor
  
Join Date: Mar 2011
Rookie Year: 2008
Location: Fond du lac Wi.
Posts: 4
cjwmam is an unknown quantity at this point
Re: Solution: Variable position of cylinder in compliance with <R74>
That's irrelevant, for the purposes of this discussion. All I'm saying is that with a 5/4 3-position valve with center pressure, you can only move the cylinder to a total of three positions - out, in, and a predetermined spot in between the two extremes


I am not sure why you say this will not work. but all I seen on our robot was I could stop and start cylinder any where in the 30" stroke. only used standard regulater on none shaft side of cylinder.