Thread: Arduino and LabVIEW
View Single Post
  #19   Spotlight this post!  
Unread 03-04-2011, 00:39
davidthefat davidthefat is offline
Alumni
AKA: David Yoon
FRC #0589 (Falkons)
Team Role: Alumni
  
Join Date: Jan 2011
Rookie Year: 2010
Location: California
Posts: 792
davidthefat has much to be proud ofdavidthefat has much to be proud ofdavidthefat has much to be proud ofdavidthefat has much to be proud ofdavidthefat has much to be proud ofdavidthefat has much to be proud ofdavidthefat has much to be proud ofdavidthefat has much to be proud ofdavidthefat has much to be proud of
Re: Arduino and LabVIEW
Quote:
Originally Posted by WizenedEE View Post
Setting a TRUE output on a DIO slot sends 5V of power down the wire. That's one bit, not 32. He's planning on using four DIO slots to send 4 bits of data to the arduino.

Just a note, you can put the PWM cable in sideways on the signal so you use two cables instead of four.

Can you put a multimeter on the slots? Can you post the arduino sketch?
Oh, then NVM me, I thought he was sending data through ethernet
__________________
Do not say what can or cannot be done, but, instead, say what must be done for the task at hand must be accomplished.
Reply With Quote