Thread: Arduino and LabVIEW
View Single Post
  #30   Spotlight this post!  
Unread 04-04-2011, 19:25
Roger Roger is offline
Registered User
FRC #1153
  
Join Date: Jan 2006
Rookie Year: 1900
Location: Walpole MA
Posts: 689
Roger has a reputation beyond reputeRoger has a reputation beyond reputeRoger has a reputation beyond reputeRoger has a reputation beyond reputeRoger has a reputation beyond reputeRoger has a reputation beyond reputeRoger has a reputation beyond reputeRoger has a reputation beyond reputeRoger has a reputation beyond reputeRoger has a reputation beyond reputeRoger has a reputation beyond repute
Re: Arduino and LabVIEW
Success! :confetti:

DIO White PWM goes to Arduino pin 7, and Arduino ground connects to DIO PWM ground Black. No resistors (any needed?). Next test is 4 DIOs. Solid 1s or 0s when buttons are pressed. Right now Arduino power is either the USB or the wall plug -- that gets changed soon.

Yeah, I took out the delay pretty early. The 1/0 list above was with no delay.

Now my lead programmer and I are arguing how to send binary numbers from LabVIEW. His method has 15 numbers -- thinking small. My method will get 256 numbers or more. Sigh -- the stars are back in alignment, world is back to normal, and programmers arguing about programming.

Thanks guys for your help. Even David -- as Sherlock Holmes says "Watson, your wrong guesses sometimes gives me the truth."
Last edited by Roger : 04-04-2011 at 19:27.
Reply With Quote