View Single Post
  #29   Spotlight this post!  
Unread 14-04-2011, 13:37
rsisk's Avatar
rsisk rsisk is offline
The GURU Channel
AKA: Richard Sisk
FRC #2493 (Robokong)
Team Role: Mentor
 
Join Date: Jan 2008
Rookie Year: 2007
Location: Riverside, CA
Posts: 2,750
rsisk has a reputation beyond reputersisk has a reputation beyond reputersisk has a reputation beyond reputersisk has a reputation beyond reputersisk has a reputation beyond reputersisk has a reputation beyond reputersisk has a reputation beyond reputersisk has a reputation beyond reputersisk has a reputation beyond reputersisk has a reputation beyond reputersisk has a reputation beyond repute
Send a message via MSN to rsisk
Re: Al's Annual Inspection Thread

Here are the procedures I used at the Radio Kiosks

1. Power up the radio
2. Switch to Bridge Mode
3. Wait until the orange light on the front of the radio blinks a couple times (about 22 secs)
4. Insert a paper clip into the "Reset" hole on the back of the radio.
5. Hold it there and count to 10
6. Remove the paper clip
7. Watch the lights on the front, they will go out after a moment, then will come back on, wait until the orange light blinks a couple times (about 45 secs)
8. Connect the radio to the Kiosk using the ethernet cable. Plug it into any of the ethernet ports on the back of the radio
9. Enter your team number into the radio kiosk program
10. Press the button on the radio kiosk program to configure the radio
11. Wait until the progress bar fills all the way to the right and it says radio is programmed (about 90 secs)

Don't try to rush the progress. If you follow these steps, it works every time.
__________________
Quote:
The views expressed are mine and should not be construed to represent the views of anyone else.

Last edited by rsisk : 14-04-2011 at 16:26. Reason: Add times
Reply With Quote