View Single Post
  #1   Spotlight this post!  
Unread 17-06-2011, 18:45
Hawiian Cadder's Avatar
Hawiian Cadder Hawiian Cadder is offline
Registered User
AKA: Isaak
FRC #0159 (Alpine Robotics)
Team Role: CAD
 
Join Date: Feb 2010
Rookie Year: 2003
Location: Fort Colins Colorado
Posts: 573
Hawiian Cadder is a name known to allHawiian Cadder is a name known to allHawiian Cadder is a name known to allHawiian Cadder is a name known to allHawiian Cadder is a name known to allHawiian Cadder is a name known to all
Re: pic: WCD Practice 2

If you are using .5 hex shafts I might consider turning them down to round where it goes through the tube, or making the slot 3/4 of an inch wide. As it is now, you have about 1/32 of an inch clearance between the slot and the axle when a flat is perpendicular to the slot, if your blocks are even slightly off, or if you powder coat, the axle might start rubbing on the tube.


Edit:
The link you posted is for the 3/8 hex bearing on andymark, I think that is why Chris assumed you were using 3/8 hex shafts,

Last edited by Hawiian Cadder : 17-06-2011 at 18:50.
Reply With Quote