We'll post a full picture tomorrow, we've been so busy preparing that we just haven't really had time for this stuff. It was really hard to get the robot programmed as all the programming mentors just got back to school Monday.
Quote:
Originally Posted by Brandon Holley
I believe I see some constant-force springs on the lift. What force rating do they have and where did you guys get yours?
Looks good! Can we see a whole picture now?
-Brando
|
They're 7 lb I believe, from mcmaster. Both mcmaster and sdp-si seem to have a similar and pretty decent selection.
Tom, these guys aren't too bad at 7 lbs, easy enough to handle by hand without cutting yourself (although I have a few times already). The 40 pounder we have but didn't use scares the heck out of me however.