Thread: Problem imaging the cRIO
View Single Post
  #1   Spotlight this post!  
Unread 04-11-2011, 13:59
Parah Parah is offline
Registered User
None #2147
  
Join Date: Nov 2011
Location: spokane
Posts: 1
Parah is an unknown quantity at this point
Question Problem imaging the cRIO
I seem to be having trouble using the cRIO imaging tool to configure the Robot to use windriver. Our robotics team previously used labview and now that we are trying to start using windriver, i can't seem to get the imaging tool to even set the cRIO to windriver. The error i'm receiving is below. The robot is connected with an ethernet cable, not wireless.


Error connecting to 'VxWorks6x_10.20.10.2'(Registry localhost). Failed to
launch target server
Possibly caused by: Back-end not connected.

Removed dead entry from Registry!
Reply With Quote