Thread: Cannot load code into emulator after upgrading firmware
View Single Post
  #2   Spotlight this post!  
Unread 11-18-2011, 04:13 PM
taichichuan's Avatar
taichichuan taichichuan is offline
Software Mentor
AKA: Mike Anderson
FRC #0116 (Epsilon Delta)
Team Role: Mentor
  
Join Date: Feb 2010
Rookie Year: 2010
Location: Herndon, VA
Posts: 328
taichichuan has much to be proud oftaichichuan has much to be proud oftaichichuan has much to be proud oftaichichuan has much to be proud oftaichichuan has much to be proud oftaichichuan has much to be proud oftaichichuan has much to be proud oftaichichuan has much to be proud oftaichichuan has much to be proud oftaichichuan has much to be proud of
Send a message via AIM to taichichuan
Re: Cannot load code into emulator after upgrading firmware
You have access to the Wind River Simulator? What version of Workbench are you using? The 2011 release of Workbench didn't include the simulator. Are you a 2012 beta-test team? If so, what version of Workbench and VxWorks are you using?

FWIW, the error you're seeing is telling you that the download was trying to write address 0xe00. That's in the PowerPC exception vector space or the x86 interrupt table if you're running the simulator. That's generally caused by a bad pointer or trying to load PowerPC code on an x86 or vice versa.

TIA,

Mike
Reply With Quote