Thread: Battery Beak
View Single Post
  #25   Spotlight this post!  
Unread 12-03-2011, 08:30 PM
Mike Copioli's Avatar
Mike Copioli Mike Copioli is offline
You make it pretty We make it dance
no team (Retired(3539, 217))
Team Role: Engineer
 
Join Date: Jan 2006
Rookie Year: 2001
Location: Romeo
Posts: 453
Mike Copioli has a reputation beyond reputeMike Copioli has a reputation beyond reputeMike Copioli has a reputation beyond reputeMike Copioli has a reputation beyond reputeMike Copioli has a reputation beyond reputeMike Copioli has a reputation beyond reputeMike Copioli has a reputation beyond reputeMike Copioli has a reputation beyond reputeMike Copioli has a reputation beyond reputeMike Copioli has a reputation beyond reputeMike Copioli has a reputation beyond repute
Re: Battery Beak

Quote:
Originally Posted by Ether View Post



Is this true even if the battery has been charged at a rate higher than 6 amps, and is hot?

Yes, surface charge is weaker than deep charge. This behavior causes a small increase in internal resistance as measured by the Beak. This increase, if the battery's internal resistance is within 10% of the threshold between 'Good' and 'Fair' or 'Fair' and 'Bad', could only cause a battery's status to appear worse than it would be if the battery had been properly rested. This is one of the reasons the 'Fair' Status exists, otherwise it would just be 'Good' or 'Bad'. If a battery is that close to the threshold you should probably reserve it for practice only.
__________________
Mike Copioli
CTRE Hardware Engineer
http://www.ctr-electronics.com

Team 3539 The Byting Bull Dogs
2013 Michigan State Champions
Team 217 The Thunder Chickens
2006 World Champions
2008 World Champions
2009 Michigan State Champions
Reply With Quote