Thread: pic: Team 3647 West Coast Drive
View Single Post
  #26   Spotlight this post!  
Unread 19-12-2011, 15:28
Mk.32's Avatar
Mk.32 Mk.32 is offline
Registered User
AKA: Mark
FRC #2485 (W.A.R. Lords)
Team Role: Engineer
  
Join Date: Jan 2011
Rookie Year: 2011
Location: San Diego
Posts: 770
Mk.32 has much to be proud ofMk.32 has much to be proud ofMk.32 has much to be proud ofMk.32 has much to be proud ofMk.32 has much to be proud ofMk.32 has much to be proud ofMk.32 has much to be proud ofMk.32 has much to be proud ofMk.32 has much to be proud ofMk.32 has much to be proud of
Re: pic: Team 3647 West Coast Drive
For the press fit bearings, should the hole be something like .001 inch undersized? Or the same as the bearing diameter?
We have an HAAS CNC we can use, I am not sure if we have any reamers so I planed to just bore them out with a 1/2 milling bit.
__________________
Engineering mentor: Team 2485: WARLords 2013-

Team President: Team 3647 2010-2013
Reply With Quote