Thread: Victor 883 problem, please help.
View Single Post
  #15   Spotlight this post!  
Unread 03-01-2012, 09:32
Unsung FIRST Hero
Al Skierkiewicz Al Skierkiewicz is offline
Broadcast Eng/Chief Robot Inspector
AKA: Big Al WFFA 2005
FRC #0111 (WildStang)
Team Role: Engineer
  
Join Date: Jun 2001
Rookie Year: 1996
Location: Wheeling, IL
Posts: 10,795
Al Skierkiewicz has a reputation beyond reputeAl Skierkiewicz has a reputation beyond reputeAl Skierkiewicz has a reputation beyond reputeAl Skierkiewicz has a reputation beyond reputeAl Skierkiewicz has a reputation beyond reputeAl Skierkiewicz has a reputation beyond reputeAl Skierkiewicz has a reputation beyond reputeAl Skierkiewicz has a reputation beyond reputeAl Skierkiewicz has a reputation beyond reputeAl Skierkiewicz has a reputation beyond reputeAl Skierkiewicz has a reputation beyond repute
Re: Victor 883 problem, please help.
No this is for a straight PWM cable.
The VEX PWM Signal driver requires 5 volts but as I remember some R/C controllers do not put out a PWM at 5 volts P-P. The signal driver simply brings that signal up to the point where the Victor input circuitry can then reliably read the signal. I have never measured a Signal Driver, so I don't know if 1950 ohms series resistance would be valid.
__________________
Good Luck All. Learn something new, everyday!
Al
WB9UVJ
www.wildstang.org
________________________
Storming the Tower since 1996.
Last edited by Al Skierkiewicz : 03-01-2012 at 09:47.