View Single Post
  #17   Spotlight this post!  
Unread 07-01-2012, 01:54
Cory's Avatar
Cory Cory is offline
Registered User
AKA: Cory McBride
FRC #0254 (The Cheesy Poofs)
Team Role: Engineer
 
Join Date: May 2002
Rookie Year: 2001
Location: Redwood City, CA
Posts: 6,819
Cory has a reputation beyond reputeCory has a reputation beyond reputeCory has a reputation beyond reputeCory has a reputation beyond reputeCory has a reputation beyond reputeCory has a reputation beyond reputeCory has a reputation beyond reputeCory has a reputation beyond reputeCory has a reputation beyond reputeCory has a reputation beyond reputeCory has a reputation beyond repute
Send a message via AIM to Cory
Re: WCP: Launch

Quote:
Originally Posted by SuperNerd256 View Post
Thanks a bunch for your help, but I may not be being clear (I have a bad habit of doing so).

The ones you linked to in the post up there ^ were to 12 tooth pinion gears, the ones normally used to go on CIM motors into CIMple boxes. I want to use the 14 tooth pinion gear normally used on the toughbox to go on the CIM motor and into the CIMple Box, and I have no idea if that will work or not.
I think you may have a fundamental misunderstanding of how gears work.

If you have a gear set with two gears that have a given number of teeth each and you wish to replace one of them, you must come up with two new gears where the sum of the tooth counts of the two new gears are equal to the sum of the tooth counts of the first two gears. Otherwise you will end up with the wrong center to center distance and they will not mesh.
__________________
2001-2004: Team 100
2006-Present: Team 254
Reply With Quote