|
Re: Imaging tool for the new 4-slot cRIO
Folks,
We finally made my way through this maze and uploaded my first test code on the FRC II. In addition to all the requirements listed above, you need to add two more:
1. Use a simple switch or hub linked only to the cRIO and your PC. Do not use the Linksys wireless router.
2. DISABLE all Ethernet ports except the hardwired port linked to the hub or switch. Simply turning off the radio is not sufficient, you must disable the port.
I hope this helps. I really appreciate the support of the folks in this forum. Good luck.
PGR
__________________
Peter Randall
Chairman, Department of Engineering & Robotics
Springside Chestnut Hill Academy
TEAM 1218
Last edited by Peter Randall : 10-01-2012 at 15:29.
|