Quote:
Originally Posted by kccowan
Do you have updated documentation on connecting the 2CAN to the new CRIO II? The new CRIO has only 1 ethernet port.
KC
|
The documentation has not been updated to reflect using only a single port.
However using the method described to connect to port one will work fine. Just make sure the IP is on the same subnet 10.x.x.x as the port you are connecting to and that the 2CAN IP is unique, the firmware utility takes care of this for you. See the attached screen shot of the firmware utility.
__________________
Mike Copioli
CTRE Hardware Engineer
http://www.ctr-electronics.com
Team 3539 The Byting Bull Dogs
2013 Michigan State Champions
Team 217 The Thunder Chickens
2006 World Champions
2008 World Champions
2009 Michigan State Champions