|
Re: Bumpers
so i found out we don't EVER take pictures of the bumpers, this is the best one i have until i can get my hands on a bumper tomorrow. this is the upper frame of our 2010 robot, you can see the pins holding the bumper in place.
the frame was 1 inch aluminum square tubing and we got aluminum C-channel that was a little more than a inch wide that fit snugly over the square tubing. each bumper was held on and we marked where the pins would go and drilled the frame there. the side bumpers were held on with 3 pins but we really only needed 2.
__________________
---------------
Bacon
|