Thread: Gears?
View Single Post
  #4   Spotlight this post!  
Unread 13-01-2012, 12:25
Retired Starman Retired Starman is offline
Registered User
FRC #3573 (Ohms)
Team Role: Mentor
 
Join Date: Jan 2009
Rookie Year: 2003
Location: Stone Mountain, GA
Posts: 165
Retired Starman has a brilliant futureRetired Starman has a brilliant futureRetired Starman has a brilliant futureRetired Starman has a brilliant futureRetired Starman has a brilliant futureRetired Starman has a brilliant futureRetired Starman has a brilliant futureRetired Starman has a brilliant futureRetired Starman has a brilliant futureRetired Starman has a brilliant futureRetired Starman has a brilliant future
Re: Gears?

Quote:
Originally Posted by ksafin View Post
Well, I meant specifically sized to the shaft of the provided CIM motors
Gears may be bored out to a larger diameter to fit the motor shaft, so if you buy a gear with a slightly smaller bore, you have a vast selection available from places like Stock Drive Products.

Dr. Bob

Chairman's Award is not about building the robot. Every team builds a robot.