Quote:
Originally Posted by kccowan
From the 2CAN firmware utility, it says the 2CAN firmware is 2.5. The bootloader version is 1.1. Man rev (not sure what that is) says 1.3 and Man Date 12/12/2009.
|
Firmware version 2.18 is the latest for FRC but 2.5 should work fine.
Quote:
Originally Posted by kccowan
Am I running the right stuff?
|
Yes.
Quote:
Originally Posted by kccowan
At some point, I saw the 2CAN light be red (flashing, if memory serves).
|
A red LED means you do not have CAN connectivity, bad cabling, bad termination resistor. If the 2CAN LED is intermittent between green and red then you have an intermittent can connectivity issue, you may confirm this in the web dash by viewing the CAN tx/rx error counter. If the error counter is incrementing you have a CAN connectivity problem.
Quote:
Originally Posted by kccowan
Do you recommend that we disconnect the bus so that only 1 Jag is on the bus at a time when we flash?
|
I have never had a problem updating JAG firmware with multiple JAG's on the BUS as long as they each have a unique ID, however when you are trying to troubleshoot, it is always a good idea to make the problem as simple as possible.
__________________
Mike Copioli
CTRE Hardware Engineer
http://www.ctr-electronics.com
Team 3539 The Byting Bull Dogs
2013 Michigan State Champions
Team 217 The Thunder Chickens
2006 World Champions
2008 World Champions
2009 Michigan State Champions