|
Re: Is this bumper considered legal?
Quote:
|
Originally Posted by [R33
]Bumpers must be supported by the structure/frame of the Robot (i.e. the gap between the backing material and the frame must not be greater than ¼ in. and no section of Bumper greater than 8 in. may be unsupported). See Figure 4‑7.
|
The rule only talks about gaps between the backing material and the frame. It doesn't state where, vertically, that gap will be measured. As long as you're on the plywood, you'll be fine.
__________________
The difficult we do today; the impossible we do tomorrow. Miracles by appointment only.
Lone Star Regional Troubleshooter
|